Profelinx Gym Cable Accessories, Nylon Ball Stopper Replacement, Eyelet Cable Terminal Interface Port, Wire Rope Joint Interface Replacement Port,

Profelinx Gym Cable Accessories, Nylon Ball Stopper Replacement, Eyelet Cable Terminal Interface Port, Wire Rope Joint Interface Replacement Port,

This gym cable ball stopper sets fit for cable with 3mm steel core. the ball is 4cm diameter, with 1cm hole. theconcave plate is 3.8cm diameter, with 1cm hole. The ball is made of hard nylon. The wire rope clamps and thimbles are made of 304 stainless steel. The concave plate, eyelet terminal, and spanner are made of metal alloy. Our cable stop set is great replacement and accessories for gym machine cable. After long time use, the ball stopper of your gym cable may be damaged. our product is the best choice for you. INSTALLATION: Use a hydraulic crimper plier tool to link the cable with the metal eyelet terminal. Put the rubber ball, bowl-shape plate and the terminal, you can use it as ball stopper set on cable machine. Put the wire rope thimble together with the clap and cable, it can use as clothesline or fence line, the thimble and clamps are wear-resistant. This cable ball stopper set includes 2 balls, 2 concave plates, 4 metal eyelet terminal, 2 wire rope clamps, 2 wire rope thimbles, 2 rubber o-rings, 2 metal ring plates, 1 mini spanner. Pulley Machine Cable Ball Stopper Replacement, Wearable Nylon Ball Stop for Cable Machine Gym Machine Smith Machine Weight Lifting Cable Ball Terminal (2 Ball-Sets)

USER INSTRUCTION:
-For a new cable, use cable to go through the hole of ball (and set other parts in right position if there are), peels a small section of plastic cover (if there is) of the cable. when connect it to a metal eyelet terminal, use a hydraulic crimper (plier) tool to squeeze the connecting part.
--if you don't use a eyelet terminal, but make the cable with a loop end, you can use a wire rope clamp or crimping loop sleeve on the cable to fasten it. you need a spanner or hydraulic crimper to process it.
- For an old cable, firstly you need to cut off the end of the cable (where there is a eyelet or loop terminal), then use cable to go through the hole of ball (and set other parts in right position if there are), and process it just same as a new cable we mentioned above.

Q&A from users
- Q: How to install the ball stopper?
- A: This is mostly for use with a new cable. The cable has to be went through the hole of the ball. Since most cables have loops at their ends, to install this on a cable that's already in service, you'd have to cut the loop off. But then the cable wouldn't be serviceable. You can get the cable and end-fittings from Home Depot, so replacing most cables is pretty easy.
- A: In my case, I had to remove the existing cable from the machine by unbolting the cable from where it was attached to the frame. I then threaded the new rubber stopper onto the cable and then ran the cable through the pulley system and back to where I had removed the cable from the frame of the machine.