Upgraded Digital W/LCD Display Control Board Replacement Parts for Pit Boss Pellet Grill Smokers AustinXL/Tailgater/Classic/Lexington Thermostat

Upgraded Digital W/LCD Display Control Board Replacement Parts for Pit Boss Pellet Grill Smokers AustinXL/Tailgater/Classic/Lexington Thermostat

👍【𝐏𝐞𝐫𝐟𝐞𝐜𝐭 𝐏𝐢𝐭𝐁𝐨𝐬𝐬 𝐂𝐨𝐧𝐭𝐫𝐨𝐥𝐥𝐞𝐫 𝐑𝐞𝐩𝐥𝐚𝐜𝐞𝐦𝐞𝐧𝐭】Upgraded digital W/LCD display control board replacement parts compatible with Pit Boss Austin XL 1000(PB1000XLW1), Classic 700(PB700FBW2 ), Lexington P7-540, and Tailgater 340(PB340TGW1).（Note: Not Compatible with Pit Boss Vertical Pellet Smoker/Refridgerator Grill and other brand grill. ) 🔥【𝐂𝐨𝐧𝐭𝐫𝐨𝐥𝐥𝐞𝐫 𝐇𝐨𝐥𝐝 𝐓𝐞𝐦𝐩 𝐁𝐞𝐭𝐭𝐞𝐫】Resolved lost control of the temp you experienced with the original. 9 cooking temperature settings, switch and set from 180°F to 500°F, fine tune temp control in 25/50°F increments. In smoke setting, you have access to 9 different pellet feeding modes(P0-P7). Hold temp better than the original. 💎【𝐔𝐩𝐠𝐫𝐚𝐝𝐞𝐝 𝐏𝐫𝐨𝐭𝐞𝐜𝐭𝐢𝐨𝐧 𝐟𝐨𝐫 𝐒𝐡𝐨𝐫𝐭 𝐂𝐢𝐫𝐜𝐮𝐢𝐭】Say goodbye to controller damage caused by short circuits. Our upgraded digital controller replacement part for pit boss is engineered to prevent controller burnouts due to ignition rod shorts. In most cases, even in the event of a short circuit, the built-in fuse will remain intact. Input: AC 120V, 60Hz (pin1-4); output: AC 8V, 200mA (pin5-8). ⚙️【𝐓𝐫𝐮𝐞 𝐏𝐥𝐮𝐠 𝐚𝐧𝐝 𝐏𝐥𝐚𝐲】You just need to put the original control board out, prepare a controller replacement parts for pit boss, then match the wire colors on each plug, an orange wire connects the fan, a red wire connects the auger motor, a purple wire connects ignitor, and a black wire connects the power in. So the entire installation is plug and play, just matching colors. 🔥【𝐀𝐜𝐜𝐮𝐫𝐚𝐭𝐞 𝐑𝐞𝐚𝐝𝐢𝐧𝐠 𝐏𝐫𝐨𝐛𝐞𝐬】Our temp probes replacement for pitboss are made of food-grade stainless steel to monitor meat temperature or grill smoker temperature. Buck design provides accurate, fast temperature sensing and alerts you to temperature changes in seconds. 💎【𝐋𝐨𝐧𝐠𝐞𝐫 𝐋𝐚𝐬𝐭 𝐈𝐠𝐧𝐢𝐭𝐞𝐫 𝐰𝐢𝐭𝐡 𝐅𝐮𝐬𝐞】200-watt/120-volt, 21" wire lead hot rod igniter is shrouded by a stainless steel sleeve that heats up for rapid pellet ignition and lasts longer. Comes with a fuse to avoid the GFCI tripping. 💝【𝐀𝐅𝐓𝐄𝐑-𝐒𝐀𝐋𝐄𝐒】100% money-back customer satisfaction, no matter if you have any questions when you receive the pit boss pellet smoker grill replacement parts, you can contact us directly, and we will give you a satisfactory reply within 24 hours and give you a satisfactory solution. Upgraded Digital W/LCD Display Control Board Replacement Parts for Pit Boss Pellet Grill Smokers AustinXL/Tailgater/Classic/Lexington Thermostat Controller Parts with Meat Probe, RTD Sensor, Igniter