AMPCOM Network Cable Tester RJ45 for LAN & TEL Continuity of RJ45/11/12 CAT5E CAT6 CAT7 UTP & STP Shielded Ethernet Wires Test Tool - W/Carrying Bag -

AMPCOM Network Cable Tester RJ45 for LAN & TEL Continuity of RJ45/11/12 CAT5E CAT6 CAT7 UTP & STP Shielded Ethernet Wires Test Tool - W/Carrying Bag -

WHAT TO TEST: AMPCOM modular lan cable tester made to check if cables with RJ45, RJ12, and RJ11 connectors are properly connected, this tester effective in detecting opens, shorts, and incorrect wiring of RJ45, RJ12, RJ11 and POE terminated cables SUPER EASY TO USE: simply turn on the"ON" switch and it's automatically starts testing. It defaults to operating in FAST mode; toggling to 'S' shifts it into a slower mode for easier see test result QUICK AND ACCURATE: RJ45 UTP: 1 to 8 lights on; RJ45 STP: 1 to G lights on; RJ12(6P6C): 1 to 6 lights up; RJ11(6P4C,6P2C): 1 to 4/1 to 2 lights on; PoE: 1/2/3/6 lights on, FAST MODE: 3-4 seconds(8 lights). SLOW MODE: 5 seconds(8 lights) IDEAL FOR: Testing to prevent new/repaired cable termination issues when running new house wiring, rewiring, and camera/video surveillance PoE cabling; testing to locate and troubleshoot network connections in installed walls, main junction boxes, etc MATERIAL: Reliable internal circuitry ensures durability. Indicator lights are brighter and clearer for easy identification. Off-On-Off button is rugged and won't slip out of place. High impact ABS plastic Housing

Introduction:

The LAN Cable Tester is designed for testing opens, shorts and miswired cable installations. A network cable tester is the most practical tool for checking and evaluating networkcable wirings.

Testing capabilities are:

1. Test pin configuration for 10/100 base -T cable, 10 base-2 cable, RJ45 modular cables, AT&T 258A cable, EIA / TIA 568A/568B cables and Token Ring Cable etc.
2. Verify cable continuity, open, short or incorrectly wired.
3. Test installed cable on wall plate or the patch panels by using the Remote Termination module.

Main Unit/Remote Unit

Display: 8 pairs LEDs for the monitors wires.

Connector: RJ-45/Key x 1,RJ-11/Key x 1.(30 micro gold plating )

Power: ONLY DC 9V battery

Dimensions:  

Main Unit: 102 x 63 x 25 mm 

Remote Unit: 102 x 35 x 25 mm.

Weight:  

Main Unit: 125g 

Remote Unit: 25g

Housing: High impact ABS plastic

Interface: Ethernet 10 BASE-T, EIA/TIA-568A, EIA/TIA-568B, AT&T 258A, TOKEN  RING, USOC8/6/4

Test for RJ-45, RJ-11, RJ-12 connectors 

OPERATION PROCEDURES

1.Plug one end of cable into jack on the main unit and other end into jack on the remote unit

2.Turn on "OFF/ON/S" Button to the middle place"ON" , If need S Mode, switch to the" S" Place : ( To see result Clearer )

3.If the cable is OK, the corresponding LED will be LIT, if NOT LIT, the cable is bad or short.