13pin Ceramic Nixie Tube Holder Socket 13 PIN 13P for IN14 IN-14 Glow Tube Fluorescent Tube

13pin Ceramic Nixie Tube Holder Socket 13 PIN 13P for IN14 IN-14 Glow Tube Fluorescent Tube

The female needle with the reed is very stable! The IN-14 glow tube is a thin lead pin designed to be soldered directly to the board. So this type of pipe is sold without a socket. However, this will cause trouble to install or replace the tube. The use of this tube holder allows the IN14 to be inserted into the socket, making installation and replacement very convenient. The pin has a hole diameter of 0.8mm and is equipped with a four-jaw reed. It is suitable for tubes with a lead diameter of 0.3-0.7mm. 1pcs IN14 Nixie Tube Holder Socket Specification:

The female needle with the reed is very stable!
The IN-14 glow tube is a thin lead pin designed to be soldered directly to the board. So this type of pipe is sold without a socket. However, this will cause trouble to install or replace the tube. The use of this tube holder allows the IN14 to be inserted into the socket, making installation and replacement very convenient.
The pin has a hole diameter of 0.8mm and is equipped with a four-jaw reed. It is suitable for tubes with a lead diameter of 0.3-0.7mm. Please remove the solder part of the disassemble tube to insert the pin.
After the pin has been used with a 0.7mm pin, the inner reed will open to the limit and lose its elasticity, so it can no longer be used for the 0.3-0.5mm pin. Please note.
The pin depth is about 4mm, please reserve the length of the pin according to your preference.
Note: For the selection of parts, the delivery is to send 13 female pins and a piece of PCB, you need to solder the female pin on the board. The finished product is already soldered to the female needle. Refer to the picture below for how to use it.