Universal Hydraulic Valve Mounting Sub Plate Aluminum D03 NG6 Cetop 3 Pattern SAE -8 Ports (1/2" Nominal Dimension Port), SA6 Series

Universal Hydraulic Valve Mounting Sub Plate Aluminum D03 NG6 Cetop 3 Pattern SAE -8 Ports (1/2" Nominal Dimension Port), SA6 Series

Clear anodized aluminum for superior surface finish, better paint adhesion and stain resistance. Uses M5-.08 thread for valve mount. The use of 10-24 threads found with many US valves can allow unsafe orientation of valve due to the smaller diameter. Therefore a locating pin is often needed with the 10-24 thread. We prefer the correct M5 thread. Standard SAE -8 3/4-16 O-ring boss ports for a leak free system. 3000 PSI maximum Pressure Note that one of the threaded valve mounting holes is offset less than 1mm to prevent mounting the valve in the wrong directions. If all bolts do not fit rotate the valve 180 degress and try again. Hydraulic sub plate for mounting D03, NG6 or Cetop 3 hydraulic valves. Valve can be bolted to the sub plate and hydraulic fittings, hoses or tubes connected to the SAE -8 standard o-ring boss threads on ports A, B, P and T. Two mounting holes for mounting the sub plate to any surface. Made from anodized aluminum. The anodized aluminum adheres better to paint and provides longer corrosion and stain resistance that just aluminum blocks. The anodizing also provides a superior looking surface finish. P=Pressure Port T=Tank Port A= A working port to actuator B=B working port to actuator. Rated to 3000psi.