Biantie La 4 Pin Led Strip Connector 10mm RGB Strip to Wire Connectors Unwired Clips Solderless Connection for Multicolor LED Strip Lights 12V 24V (

Biantie La 4 Pin Led Strip Connector 10mm RGB Strip to Wire Connectors Unwired Clips Solderless Connection for Multicolor LED Strip Lights 12V 24V (

QUICK AND FLEXIBLE CONNECTION: Connect rgb strips to wire without stripping insulation, no soldering. The Alightings 4pin led light connectors are suitable for 10mm rgb LED strip lights, can also be applied to both non-waterproof and IP65 waterproof light strips. One end connects 4-conductor 22 gauge extension cable and another end for rgbw led strip. The led tape light connectors can not work with 8mm led strips, 3528 rgb led strip, or 20 awg wire. FREE FROM THE LIMIT OF TERMINAL POSITION: Connect wire by yourself as need, use these rgb 4 pin led connectors with 22 gauge 4 conductor extension cable to get lighting exactly where you want it. No mater board to wire input or strip to strip jumper, extension distance and angle are no more problems to you. STRONG COMPATABILITY: The led strip connector compatible with 5v, 12v, 24v led light strips, work for IP20/ IP65 10mm width 5050 RGB 4 Soldering Pads tape light. You only need to align the front side (led surface) of the light strip with the pins of the connector, and then buckle the transparent cover to achieve a stable and good connection. Suit for 22 awg 4 conductor wire, solid wire and multi-core wire. SOLID & EFFECTIVE CONNECTION: High quality tin plated copper core and PVC plastic wire cover ensure steady, safety and long-lasting connection, firmly bite through the led light strip, much stronger than old style lights connectors, The clear terminal is easier to pierce the wire, and the one-time success rate is higher. SOLDERLESS AND CONVENIENT: Simply slot the strip light and 22awg wire into connector and clamp the cover. Fits all 10mm width 5050 RGB LED strips. Perfect for NON-WATERPROOF or IP65 WATEREPROOF LED Tape Light DIY project (NO need to peel off silicone cover for the waterproof strips.) These 4-pin strip to wire connectors are solution for 10mm 5050 RGB LED strip lights connection and extension needs, DIY extention for whatever the cable length you want to connect. NOTE: 1. Make sure your LED light strip is 10mm width RGB strip lights with 4 Soldering Pads. Not work for 8mm or 12mm width led light strips. Installation tips: Strip End: 1. Cut the strip straight perfectly, then fully open the clip. 2. Insert the light strip, align the 4 Soldering Pads of the light-emitting surface of the light with the 4-pins on the connector. Then press down the transparent cover. (Note: No need to peel off the silicone on the surface of led light strip when you want to connect WATERPROOF LED strip.) Wire End: 1.Cut the desired wire length you need and separated the 4 wires around connection part. 2. Insert wires into the connector guide slot, make sure that positive and negative on the strip light surface are corresponding to the wires. 3.Close the transparent cap with a pliers and press down hard for several times. Ensure the metal joint pierces through the wire insulation as there are so many non-standard wires on the market! 4. reminder: no stripping of the wires. Just be sure polarity nodes are matched up "+" to "+" and "-" to "-". If you have any problem about installation, pls feel free to contact us. Package: 10pcs Strip to Wire Connectors (BL-TZ10XB-4)