Pneumatic Bottle Capper Handheld Bottle Capping Sealing Machine Screwing Capping Tools 2500RPM for 20-40mm Plastic Bottle Caps

Pneumatic Bottle Capper Handheld Bottle Capping Sealing Machine Screwing Capping Tools 2500RPM for 20-40mm Plastic Bottle Caps

【Pneumatic tools】Driven by air pump,This bottle capper is easy and safe to use. No need to be limited by voltage, you can tighten or open the bottle lids anywhere. Please note that you need to prepare an air compressor over 40L and the air pressure needs to be 5-6KG/cm³. Or it can not work. 【Good clamping】The cap sealer adopts metal jaw-type claw, which can tightly hold the capping head to prevent it from dropping. After installing the capping head, you can turn into different directions to clamp. It also uses quality core gears,allowing the capper to high rotating speed and long-lasting clamp. 【Adjustable sets】With speed knob, the rotating speed of bottle capper can be adjusted in several levels. Maxinum speed can reach to 2500rpm, efficient capping. Also set with direction knob, you can flexibly to change it for different direction selection. Forward to capping, reverse to tighten. 【Handheld design】Comply with ergonomic design, the bottle capping machine features with anti-slip body and compact size, comfortable to hold and agile to operate. Even after long time work, your wrist and hand will not feel fatigue. The tap switch also makes it easy to start and stop, suitable for semi-automatic lines. 【Applications】With two sizes of capping heads, this bottle capper is suitable for 20-40mm flat plastic caps with teeth on sides. Such as water bottles, drink bottles, medicine bottles, glass water bottles etc. It can not be used for glass caps, sprayer head, dropping bottle caps. Specifications:

Rotating speed:2500rpm
Air inlet diameter: 3/8"
Joint diameter: 1/4”,
Air consumption: 4.0CFM
Chuck size: 10mm
Clamping range: 1.5-10mm
Machine size: 300 x 60 x 60mm
Weight: 0.7kg


How to install the cap head:

1. Unscrew the cap head required (the top cover of this product is equipped with a small rubber ring, which can be easily removed).
2. Choose the suitable rubber pads.（Among them, the metal heads of 10-20mm and 20-30mm specifications are common, and the metal heads of 30-40mm and 40-50mm specifications are common.）
3. Press the rubber pad in the metal head and then screw it up.


Notes:

1. An air compressor over 8L is needed. Please make sure the air pressure is between 5-6KG.
2.If your bottle cap is spray type or other shape, please contact us.