Fasco Epoxies Fas-Fair #26 Epoxy Fairing Compound Quart Kit

Fasco Epoxies Fas-Fair #26 Epoxy Fairing Compound Quart Kit

✅ High-Strength Fairing & Gap Filling — Lightweight, durable compound ideal for fairing surfaces on fiberglass, metal, wood, foam, masonry, and many plastics. 🎯 Easy 1:1 Mix Ratio — Just mix the white and red components until color is uniform; creamy consistency spreads smoothly and holds on vertical/overhead surfaces without sagging. ⏱ Fast Cure / Ready to Sand in ~4 Hours — At ~76 °F, the compound cures quickly and becomes easy to sand — ideal for faster project turnaround ✂️ Sands Easily & Feather-Edges Cleanly — Once cured, the compound sands to a fine finish and blends seamlessly with surrounding surfaces. 🎨 Paint & Primer Compatible — Works well under both latex and epoxy primers / paints, allowing for smooth finishing after fairing. ⚖️ Lightweight & Structural — Designed to offer good strength without unnecessary weight; useful where structural adhesion and minimal added weight are important.

DESCRIPTION A light weight compound for fairing surfaces of fiberglass, metal, wood, foam, masonry, and most plastics.

Fas-Fair 26 is a Fasco Faring Compound for filling dents, scratches, mars and surface imperfections of all kinds. It has the following outstanding characteristics:

Excellent adhesion to fiberglass, metal, foam, concrete, wood, and most plastics Lightweight putty which can be applied on vertical surfaces in a thickness up to 3/8" without sagging Easy sanding Dries to glossy, impermeable surface Fast setting - Can be sanded in 3 hours at 76 degrees F.

USES

Filling in blisters in fiberglass boats Filling dents in autos where superior adhesion is necessary and desirable Faring rough surfaces prior to priming and painting . Protecting and faring Styrofoam surfaces Lightweight epoxy glue Filling cracks and crevices in concrete floors Surfacing wood, fiberglass, aluminum and steel boats Sealing dents in aircraft surfaces

SURFACE PREPARATION

Surface to be fared should be clean, dry and sanded.

MIXING

Fas-Fair 26 is an equal part mix. Mix Part 1 and Part 2 together thoroughly until a uniform color is achieved with no streaks.

POT LIFE

A one-quart mass of mixed Fas-Fair 26 will gel in the mixing pot in 25 minutes at 76 degrees F. Higher temperatures will make it gel quicker and low temperatures will extend the pot life. Pot life also depends on the amount mixed. Thick mass gels fast - thin films take much longer to gel and cure.

APPLICATION

Fas-Fair 26 may be applied by plastic spreader, trowel, or putty knife. It may be applied vertically, without sag, up to 3/8" per coat or horizontally as thick as desired.