BuySwings Commercial Half Bucket Toddler Swing Seat - Perfect for Outdoor Playground Areas, Steel Reinforced Synthetic Rubber Prevents Fading and

BuySwings Commercial Half Bucket Toddler Swing Seat - Perfect for Outdoor Playground Areas, Steel Reinforced Synthetic Rubber Prevents Fading and

LAP CHAIN INCLUDED to prevent small children from falling out. HEAVY DUTY RUST RESISTANT welded triangular hardware. An astonishing tensile strength of 3000 lbs. EPDM RUBBER prevents crazing, cracking and oxidizing to hold up well in extreme temperatures, both very hot and very cold. An exceptional tot seat with tab and ring for adding an A110 Safety Chain which is sold separately. The dimensions of the seat are 12” diameter, 8.5” in depth and the back holes are 5 3/16” in length. It is made of 5/16” thick EPDM rubber with a one piece insert to resist vandalism and welded triangular hardware. Our seats are made of EPDM rubber that is made especially for our swing seats. The rubber does not rub off on children’s clothes and the seats last much longer than natural rubber swings. Unlike seats made of polymer, seats made of EPDM rubber hold up well in extreme temperatures, both very hot and very cold. EPDM: Ethylene-propylene-diene-monomer is a synthetic rubber material which helps prevent crazing, cracking and oxidizing. Natural rubber is often made from recycled tires etc., and you are never sure what the actual rubber mixture is. It often wears off on children’s clothes. It cracks and crazes, making the seat unsightly and allowing moisture to get into the seat. This makes the seat deteriorate at a much quicker rate. Our seats have galvanized steel triangles and steel plates that are riveted to the seat with galvanized rivets. We go to the added expense of welding each triangle together so they cannot be pulled apart and pulled off the seat. We believe our swings are one of the few that have these welded triangles. The triangle is constructed of 3/8” dia. cold rolled steel with the ends welded together. The plate is 1/16” thick h.r. stamped galvanized steel. The rivets which are used to rivet the plate through the EPDM rubber and steel insert are made of 1/4” diameter steel. There are three rivets on each side of the seat. The S150 seat has a 1075 steel insert full hard painted with a non-rusting adhesive, and then coated with rubber that is from ¼” to 3/8” thick. Tensile strength is 3000 lbs.