Black Ice Snowmobile Dolly, Heavy-Duty Powder-Coated Steel Lift with 1500 lb Capacity, Folding Design with Large Casters & Long Lever Handle for

Black Ice Snowmobile Dolly, Heavy-Duty Powder-Coated Steel Lift with 1500 lb Capacity, Folding Design with Large Casters & Long Lever Handle for

MOVE SNOWMOBILES BY HAND USING SIMPLE LEVERAGE: Lower the front bar and slide it between your skis and track at a 90-degree angle, with the long handle pointed towards the rear; using the handle, pull down until the front end of your snowmobile is completely lifted onto the plastic padded front bar; the front bar and lifted front end will then act as a fulcrum, allowing you to simultaneously lift the tail end of your snowmobile and slide the long handle at an angle under the track DURABLE STEEL CONSTRUCTION: Manufactured in durable powder-coated 1.25" square steel tubing; plastic front covering protects dolly and sled; rubber padding protects dolly from tracks with studs ASSEMBLY REQUIRED: Arrives ready to assemble with all necessary components UNIVERSAL SIZE ACCOMMODATES MOST SNOWMOBILES: Measures 83.25" L x 46.25" W x 20.378" H; 5" diameter 1.125" thick front casters, 3" diameter 1.20" thick rear caster FOLDS UP FOR COMPACT STORAGE: Folds to 83.25" L x 20.378" W x 10" H The Black Ice Snowmobile Dolly is an easy-to-use, space-saving alternative to large snowmobile jacks and dollies. It allows you to fully lift your snowmobile's skis and track off the ground and reposition your ride for storage or maintenance. Constructed with durable powder-coated 1.25-inch square steel tubing, this dolly comes with two large front casters (each 5 inches in diameter and 1.125 inches thick), one small rear caster (3 inches in diameter and 1.2 inches thick), and a long lever handle to support the track and help maneuver the snowmobile once it's fully lifted. It requires no electricity, batteries or hydraulics to operate. This dolly folds up to 83.25 inches long by 20.375 inches wide for compact storage, and is lightweight at 35 pounds. Plastic padding on the front bar protects the sled and dolly from damage, while a 17.75-inch long rubber strip on the back prevents tracks with studs from scratching the long handle. To use this snowmobile dolly, lower the front bar and slide it between your skis and track at a 90-degree angle, with the long handle pointed towards the rear. Using the handle, pull down until the front end of your snowmobile is completely lifted onto the plastic padded front bar. The front bar and lifted front end will then act as a fulcrum, allow(more...)