Front HVAC Heater Blower MotorFit for Honda Odyssey 05-10, for Subaru Legacy Outback 05-09, for Toyota RAV4 04-05, Assembly with Fan Cage Replaces

Front HVAC Heater Blower MotorFit for Honda Odyssey 05-10, for Subaru Legacy Outback 05-09, for Toyota RAV4 04-05, Assembly with Fan Cage Replaces

FITMENT: Fit for Honda Odyssey Rear 2005-2010(not for submodel DX; NHL SE), for Subaru Legacy 2005-2009 Front (not for submodel 2.0; 2.0R; 2.5i Touring; 3.0; 3.0 R Premier; Base; Touring), for Subaru Outback 2005-2009 Front (not for submodel 2.5 XT; 3.0 R; 3.0 R Premier; Premier; Touring), for Toyota RAV4 2004-2005 Front REPLACE: 700202, 79220-SHJ-A01, 79220-SHJ-A02, 87103-42060, PM9314 FUNCTION: HVAC Blower Motor with Fan is responsible for producing air that goes through the vents of your vehicle's AC and heating system. If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor. HIGH QUALITY: Every Blower Motor must take inspected and tested multiple times before the shipment, our Blower Motor with strong heat dissipation, reduce the rate of burning electronic parts NOTE: Please check the product description and compatibility chart prior to purchase to confirm this replacement fits your vehicle

FITMENT:

* Fit for 2005-2010 Honda Odyssey 3.5L
* Fit for 2008-2009 Legacy 2.0L
* Fit for 2005-2009 Legacy 2.5L
* Fit for 2008-2009 Legacy 3.0L
* Fit for 2005-2009 Outback 2.5L
* Fit for 2005-2009 Outback 3.0L
* Fit for 2004-2005 Toyota RAV4 2.4L



Replaces Part Numbers:

* 700202,
* 79220-SHJ-A01
* 79220-SHJ-A02
* 87103-42060
* PM9314



How to replace with new HVAC blower motor?

* 1 Always wear eye protection and start with installation tools.
* 2 Locate the HVAC blower motor under the passenger side dash. Removing the dash may be necessary to access the blower motor on some vehicles. (Note: On older vehicles, the blower motor may be * located in the
engine compartment on the passenger side firewall.)
* 3 Disconnect the blower motor electrical connector.
* 4 Remove the retaining screws to the blower motor assembly.
* 5 Remove the box and blower motor assembly.
* 6 Remove the blower motor retaining screws. Remove the motor from the box.
* 7 Compare the new blower motor to the old one to verify that you have the correct part. Install the new motor into the box and tighten the retaining screws. Re-install the blower motor assembly.
* 8 Connect the blower motor electrical connector.
* 9 Operate the heating and A/C system. Verify that the blower motor operates at all speeds and that the system produces hot and cold air.
* 10 Searching related installation video on the internet will be also recommended.