RW 0059-005 JIS (Japanese Industrial Standard) Screwdriver Impact Bits #2#3 Standard & Long 1/4 Inch (Set of 4, 1 of Each)

RW 0059-005 JIS (Japanese Industrial Standard) Screwdriver Impact Bits #2#3 Standard & Long 1/4 Inch (Set of 4, 1 of Each)

JIS (Japanese Industrial Standard) Screwdriver Impact Bits Contains (4) bits total: (1) JIS #2 Short 25mm size, (1) #2 Long 75mm size, (1) JIS #3 Short 25mm size, (1) #3 Long 75mm size Hardened and Magnetic Made of S2 Steel Excel with vintage machines with hard to remove fasteners. These do not slip out Made out of heavy duty steel. These will be the only set of JIS drivers you will ever need.

- Contains (4) bits total: (1) JIS #2 Short 25mm size, (1) #2 Long 75mm size, (1) JIS #3 Short 25mm size, (1) #3 Long 75mm size
- Made of S2 steel
- Hardened bits are magnetic
- Excel with vintage machines with hard to remove fasteners. These do not slip out

JIS screws are used by most manufacturers of motorcycles, snowmobiles, ATV, UTV, 3-Wheelers, PWC'S and a ton of other products made in
Japan.

With old rusty screws that are hard to remove, the middle ground will not cut it.

Included in this 1/4" impact driver set:
(1) #2 JIS Impact Driver Bit Short 25mm
(1) #2 JIS Impact Driver Bit Long 75mm
(1) #3 JIS Impact Driver Bit Short 25mm
(1) #3 JIS Impact Driver Bit Long 75mm

Most "JIS" advertised screwdrivers sold today are made to a new standard: DIN 5260 which is middleground between Phillips and JIS.

If using the right tool for the job is important to you or if you frequently work with Japanese or JIS screws consider investing in
proper JIS screw driver bits that are built to to the correct Japanese Industrial Standards (B 4633).

There are the real JIS and the not-so-real JIS screwdrivers. Remember JIS is a standard so a screwdriver needs to be made to that
exact standard to be considered authentically JIS.

Most JIS advertised screwdrivers sold today are actually conforming to a new standard DIN 5260 which is identical (at the tip) to the
newer ISO 8764-1.

Phillips screws by design were created to cam-out.

JIS drivers are re-engineered standards that aim to reduce or eliminate cam-out.

Even though the JIS & Phillips looks very similar, they are two different designs and the drivers are not meant to be interchangeable. Using one in the other will lead to frustration and stripped out screws.