CNYST Fruit Hardness Tester Fruit Penetrometer with 1 Pressure Head Measurement Range 0.4 to 30kgf/cm2 (x 105 Pa)

CNYST Fruit Hardness Tester Fruit Penetrometer with 1 Pressure Head Measurement Range 0.4 to 30kgf/cm2 (x 105 Pa)

◆ Digital display,easy reading,high precision; Measurement Range: 0.4～30kgf/cm2 (×105 Pa) ◆ Light weight,small size,easy to carry; Load scale value: 0.01kgf/cm2, Precision:±1% ◆ Pressure needle diameter: Ø7.9mm, Depth of pressure needle: 10mm ◆ Four,Button function, “OFF/ON”, ”ZERO”, ”SET”, UNIT””,(PS:Scientific use of the measurement range is 10%-100% of full range,suggest measurement department do not to test below 1% of full range.) ◆ The Digital Fruit Sclerometer has advantages of simple structure, accurate reading and easy to operate The Digital Fruit Sclerometer has advantages of high precision,easy operation and carry.It can test fruit like watermelon.

Technical Specifications
* Measurement Range: 0.4～30kgf/cm2 (×105 Pa)
* Load scale value: 0.01kgf/cm2
* Precision:±1%
* Pressure needle diameter: Ø7.9mm
* Depth of pressure needle: 10mm
* Power: 3.7V lithium battery
* Charging time: 4~6 hours
* Continuous usage time of battery:About 10 hours
* Battery life: ≥300times
* Charger: Inpu: AC 220V 50/60HZ; Output: DC 5V 1000mA
* Stability: Temperature drift: 0.2uV/℃（0-60℃）
* Zero temperature drift: ≤ 0.1%/8 hour/FS
* Work temperature: 5℃～35℃
* Transport temperature: 0℃～60℃
* Relative humidity: 15％～80％RH
* Work conditions: No focus ,Non-corrosive in surroundings
* Net weight: About 260g
* Size:160mm×71mm×35mm

Characteristics:
1.Standard fruit hardness unit display:kgf/cm2
2.The battery has over-load protection in case of short circuit and leakage of electricity .It also can tell you when the battery is running low.It adopt the 3.7V lithium battery and auto shut off if no operation in 10 minutes.
3.Two test mode:Peak hold and Real-time;

Four,Button function
OFF/ON
(start up ,shut down key):When press this key,turn on the power,appear measuring interface.Press this key again can shut down gauge.
ZERO
(zero key):The testing value on the screen can be zero when click this key.
SET
(switch mode key):When press this key,enter the ”Peak” mode.Press “SET“key for 4-5 seconds after starting up,and then loosen,can enter into the setting interface.
UNIT
(unit key)Press “UNIT“key for 4-5 seconds,the digital value inverted display.