ACC Automotive Carpet Compatible with 1988 to 1998 Chevrolet Standard Cab Pickup Truck (8078-Dark Grey Plush Cut Pile)

ACC Automotive Carpet Compatible with 1988 to 1998 Chevrolet Standard Cab Pickup Truck (8078-Dark Grey Plush Cut Pile)

This item is made in 8078-Dark Grey Plush Cut Pile carpet. The item image may be a different color, but the SWATCH image is the correct color. Unless otherwise noted, the jute padding is heat bonded to the backside of the carpet and a heel pad is welded to the correct location. Holes may not be cut in automotive carpet and carpet may require trimming to install. Automotive carpet compatible with Chevrolet Standard Cab Pickup Truck will be Heat and Pressure formed using a form that was created from the original floor pan. Carpet will fit to the floor when installed correctly. All automotive carpets are Made in USA with Top Quality auto carpet materials. Carpet samples are available if you are not sure of the material or color you need. Automotive carpet will fit just like original carpet when installed correctly. This item fits the years: 1988-1998

• This automotive carpet will be made in 8078-Dark Grey Plush Cut Pile. Other colors and materials may be available in the selection above.
• This automotive carpet is a replacement for 1988 to 1998 Chevy Standard Cab Pickup Truck. Will fit either 2wd and 4wd models. Will fit 1500, 2500, or 3500 series.
• Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to Massbacking.
• Unless specified, the jute padding will be attached in the foot area of the carpet
• Installation may require trimming around the edges and the holes may need to be cut.
• There is a large variety of colors available. Please request free samples if you want to match a specific color

READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets

1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.

Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.